The weakest part decides
A rural fence lasts as long as its weakest part, and around Tamworth that is usually a strainer that has started to lean or a timber post that has gone at ground level. The wire often outlasts both. No public source we read gives a figure for a whole fence, so this page does not either. It explains what wears a fence out and what you can ask for.
Timber in the ground
A timber industry education body rates species into four durability classes for in-ground contact, with class 1 the most durable. It says fence posts should ideally be durability class 1 or 2, which should give at least 15 years in the ground, and that treated softwood posts should be specified to the H4 treatment level (timber industry guidance).
What that means when you read a quote:
- "Hardwood" is not enough. Ask for the species and its class.
- "Treated pine" is not enough. Ask for the treatment level and look for the mark on the posts.
- Durability ratings apply to heartwood. Sapwood is far less durable unless treated.
Old split ironbark and box posts are still standing on many places around Tamworth, which shows what good heartwood can do. A new post of unknown species and grade is not the same thing.

Steel and wire
Steel posts and wire do not rot. They rust once the protective coating is used up. How long that takes depends on the coating weight and on what the wire touches. One manufacturer's data sheet for hinge joint netting claims its heavier coating lasts several times longer than standard galvanising (one manufacturer's data sheet). That is the maker's claim and we cannot test it. It is still a reason to ask what coating you are being quoted.
| Part | What wears it out | What to specify or do |
|---|---|---|
| Timber strainers and posts | Decay at ground level, fire | Species and durability class, or treatment level |
| Steel posts | Rust after coating loss, bending by stock or machines | Post weight and coating |
| Wire and netting | Coating loss, overstraining, heat from fire | Grade and coating class |
| Strainers | Leaning under load, worst in soil that swells and shrinks | Depth, footing and stays |
| Gateways | Sagging posts, stock crowding, vehicles | Bigger posts and gate supports |
| Crossings | Flood debris and scour | Separate sections at each crossing |
Heat, fire and dry ground
Tamworth's climate is hard on fences in its own way. The Bureau of Meteorology's airport station averages a January maximum of 33.1 degrees and 659 mm of rain (Bureau of Meteorology). Dry, cracking clay lets strainers rock. Timber checks and splits. And fire is frequent: the Rural Fire Service reports around 270 bush and grass fires a year in the Tamworth Regional area (NSW Rural Fire Service). A fence through grass that burns every few seasons will not reach its rated life no matter how good the timber is.
Water and stock
Floods end fences early. Victorian Government guidance for riparian fences in flood-prone areas, an interstate source, says no fence is built to survive a major flood, which is why it recommends separate sections at crossings that can be lost and replaced on their own (Victorian riparian fencing guidance).
Cattle wear a fence every day by leaning, rubbing and reaching through for feed. A hot wire on offsets keeps them off it. See electric fencing. And neglect matters: a fallen branch left on the wire or a broken strand not tied off costs little in the first month and a lot by the second summer.
Repair or replace
If the strainers are sound and the wire still takes tension, replacing posts and re-straining is often good value. If the strainers lean and the wire snaps when tightened, the fence is done and patching it costs more in the end. A contractor can test a section in minutes. See the cost guide for what a replacement quote should cover, and cattle and sheep fencing for the options.
What this guide cannot tell you
It cannot tell you how many years your fence, wire or posts will stand. The one figure here is an industry body's expectation for class 1 or 2 timber in the ground, not a promise and not specific to Tamworth soils. It cannot check a manufacturer's claim. It cannot inspect your fence. Before you decide how much to spend on an old fence, have a contractor test the strainers and the wire.
Check the current rules before you rely on this
This page describes what public sources say about timber post durability, wire coatings, fire activity and fences on flood-prone ground. It describes the rules in general terms as they stood in November 2026. Standards, forms, thresholds and fines change.
The authoritative sources are Australian timber industry education body, fencing (durability classes and treatment), One manufacturer's hinge joint livestock fence data sheet (manufacturer claims are the manufacturer's), Bureau of Meteorology, Tamworth Airport AWS climate statistics (station 055325), NSW Rural Fire Service, Tamworth district information pack and Victorian Government, guidelines for riparian fencing in flood-prone areas (2015; Victorian guidance, interstate). Where anything here differs from those sources, they are right and we are not.
We are not fencing contractors, builders, regulators or lawyers. For what applies to your fence, ask the contractor which licence or registration they hold for your job, then ask NSW Fair Trading or Building Commission NSW if you are unsure, and ask the council that covers the land.
Accurate at the time of writing, November 2026. Always check the source before relying on it.