Home  /  Choosing a contractor

Choosing a rural fencing contractor around Tamworth

What to ask a rural fencing contractor around Tamworth before you agree, how to read the written quote, and which licence and insurance questions to raise first.

Licence and insurance

Licensing rules differ by job. The NSW Government fencing page we found speaks about fencing on residential property boundary lines, and we could not confirm that it covers rural or farm fencing. Ask the contractor which licences and insurance apply to your job, check NSW Government licence guidance, and ask NSW Fair Trading or Building Commission NSW if you are unsure.

The page referred to is the NSW Government fencing work page, and its companion categories of work page lists fencing work without mentioning paddocks or farms. So this guide does not tell you what a rural fencer must hold. It tells you what to ask, and it is the contractor who is responsible for holding any licence or registration that applies.

For insurance, ask to see a current certificate for public liability, check the business name and dates, and ask how anyone working on site is covered if they are hurt.

Questions worth asking

QuestionA good answer sounds like
How far is my place from your base, and is travel in the price?A clear yes or no, and a figure if it is extra
Where can I see fences you built a few years ago?Roads you can drive along to look
Will you be on the job, or a crew?Who will be there each day
Which wire, grade, posts and spacing are you quoting?Product names and numbers
How will you set strainers in my soil?Depth, footing and stays, explained
What happens if you hit granite or the ground is too hard?A rate, written down
How do you handle the creek crossings?A plan for each one
Who checks for powerlines and buried services?A name and a when
How is payment staged?Deposit, materials and final payment, in writing
If a wire goes slack early on, will you come back?Yes, and it is on the quote

Experienced rural fencers usually answer most of these before you ask. That is a good sign on its own.

Steel posts, treated pine strainers, a roll of barbed wire and a coil of plain wire stacked by a steel farm gate near Tamworth, with a tape measure and a blank clipboard hanging on the gate
Check what turns up on site against what the quote named

A quote you can rely on

A good quote is in writing, itemised, and detailed enough that a different fencer could build the same fence from it. It should state:

  • the metres quoted and how they were measured,
  • the wire type, product and grade, and the number of lines,
  • post material, size and spacing,
  • strainer and stay details, with timber class or treatment,
  • each gate and grid and its width,
  • each crossing and how it is built,
  • whether the old fence comes out and where it goes,
  • what happens on rock or hard ground,
  • who supplies materials,
  • payment stages, and
  • the licence and insurance details the contractor says apply.

On a boundary, ask for the quote to be addressed to both owners with extras on separate lines. Farm boundary fencing explains why.

If another fencer could build the same fence from the quote, it is a quote you can rely on.

Safety on your place

Fencing brings post drivers, augers, tractors and tensioned wire onto your land. SafeWork NSW's farm machinery guidance stresses guards on post hole diggers and power take-offs, rollover protection on tractors and trained operators (SafeWork NSW). The regional electricity network operator says to keep at least 8 m from powerlines (network operator safety guidance). Point out every powerline, pipe and buried cable you know of before the first post goes in.

Red flags

Be wary of a contractor who will not put the price in writing, wants all the money before starting, cannot point to a fence you can look at, is vague about the wire and posts, or says no neighbour, council or service check is needed without asking where the fence is. Any one of these can have an innocent explanation. Several together suggest a job that will be hard to sort out if it goes wrong.

Finding one

Many rural fencers around Tamworth get their work from other landholders and have little presence online. Send your job through the quote form and it goes to a contractor who works your district. You can still get other quotes, and the cost guide helps you compare them.

What this guide cannot do

This guide cannot vet a contractor for you or confirm that anyone holds a licence, registration or insurance, and it cannot say which of those the law requires for your fence, because the public pages we found do not answer that for rural work. It cannot judge workmanship or settle a dispute about a finished job. The people to ask are the contractor, NSW Fair Trading and Building Commission NSW.

Written November 2026

Check the current rules before you rely on this

This page describes what to ask a rural fencing contractor around Tamworth and what the NSW Government pages we found do and do not say about fencing licences. It describes the rules in general terms as they stood in November 2026. Standards, forms, thresholds and fines change.

The authoritative sources are NSW Government, fencing work (licences and credentials; speaks about fencing on residential property boundary lines), NSW Government, categories of building and trade work (lists fencing work; no rural or agricultural mention), SafeWork NSW, machinery on farms and Electricity network operator, electricity and agriculture safety guide (PDF). Where anything here differs from those sources, they are right and we are not.

We are not fencing contractors, builders, regulators or lawyers. For what applies to your fence, ask the contractor which licence or registration they hold for your job, then ask NSW Fair Trading or Building Commission NSW if you are unsure, and ask the council that covers the land.

Accurate at the time of writing, November 2026. Always check the source before relying on it.

Questions

Common questions

What licence should I ask a rural fencer about?

Ask which licence or registration they hold and why they think it applies to your job. The NSW Government fencing page we found speaks about residential boundary fences and does not mention farm fencing, so this site does not say what is required. NSW Fair Trading or Building Commission NSW can help if you are unsure.

How do I check a fencing contractor's insurance?

Ask for a certificate of currency for public liability. Check the business name matches the quote and that the dates cover your job. Ask how workers are covered for injury. If the answers are vague, ask again before anyone starts on your property.

Is the lowest fencing quote a bad sign?

Not by itself. Find out what is different. It might be lighter wire, wider post spacing, fewer strainers, no rock allowance or no old fence removal. Compare line by line. If it really is the same fence, the contractor may simply want the work.

Should every fencing quote be in writing?

Yes. Even a small job is worth a short written quote. You may need it for a neighbour, an insurer or an assistance application. A single figure in a text message is fine for a quick repair but not for a new fence.

How do I judge a finished fence?

Walk it. Strainers should not move when you pluck the wire, tension should be even, posts straight and at even height, netting tight to the ground through dips, and gates hanging level and latching. Raise anything before the final payment while the contractor is still about.

Can I see a contractor's earlier work?

You should be able to. Fences are easy to inspect from a road. Look at one that has been through a few seasons, not only a new one. Ask the landholder how the job went if you know them.

What if the contractor hits rock halfway through?

What happens should be on the quote before work starts: a rate per hole, an hourly rate or moving the post. If the quote says nothing, stop and agree the extra in writing before the contractor carries on, so the invoice holds no surprises.

Who pays if a contractor damages a buried pipe or cable?

That depends on what was agreed and who knew what. Mark every pipe, cable and drain you know of, tell the contractor, and agree in writing who arranges a service location check. Their public liability insurance is there for this, which is why you check it first.

Next step

Send the paddock, the stock and a photo

Say the district, what the fence has to hold or keep out, a rough length and the ground. A contractor who works that country can take it from there.